Easy DVD Burning

DVD neXt Copy SimpleX is the fifth installment of the popular DVD software series by DVD neXt Copy (Next Tech and Ultimate). Installing DVD neXt Copy SimpleX into your computer is a very straighforward. Just proceed with the steps below and you’ll do just fine.

System Requirements:

Minimum:

• Windows 2000, XP
• Pentium III 500MHz or equivalent
• 256 MB of RAM
• 10 GB of free hard drive space
• A DVD writer and Media

Recommended:

• Windows XP, VISTA, Windows 7
• Pentium IV 1.4GHz or equivalent
• 512 MB of RAM
• 10 GB of free hard drive space
• A DVD writer and Media

If your PC meets the minimum system requirements of this DVD copying software as stated above, you may proceed to the installation procedure below.

1. Download and save the DVD burning program in your hard drive.

2. Run and install the DVD burning program. The DVD software installer’s Setup Wizard will open. After you specify a language, click ‘Next’.

3. Click next again.

4. The Setup Wizard will take you to the License Agreement page. Read the statements and click ‘I Agree’ (assuming you agreed with the terms of the agreement).

5. The DVD software installation process will now begin. Depending on the speed of your computer, the installation process will be completed by 3 to 5 minutes.

Important:
Please note the allowed installation is limited to only two computers for each Next Tech License Code purchased.

After the installation is completed, you will be automatically redirected to Next Tech’s License and Product Activation panel as you run DVD Next Copy neXt Tech the first time.

Activation:

Step 1: Make sure you are connected to the internet. Run DVD Next Copy neXt Tech and click on the middle link in the License popup to start the License Manager. It may take up to 30 seconds for the license manager window to open, while it checks with the activation server.

Step 2: Enter your license you received with your purchase email. You may copy and paste you license code into the field. If you type in your license code, use only the number (0) and not the letter O. Click on Activate.

Step 3: You will receive a popup telling you that your software successfully activated. Click on OK.

Congratulations! You have successfully installed DVD Next Copy SimpleX on your computer.