easydvdburning.com
Software Installation PC DVD Next Copy Next Tech Installation Guide
 

DVD Burning Software Installation Guide - DVD Next Copy next Tech

DVD Next Copy Next Tech is the fourth installment of the popular DVD software series by DVD Next (Copy Standard Copy Pro and Copy Ultimate). It has all the essential features of the previous Next Tech dvd burning softwares that made the label so popular – plus several more. It’s our guarantee; you’ll love your new copy DVD software from DVD Next in no time.

Installing DVD Next Copy next Tech into your computer is mighty easy. Just proceed with the steps below and you’ll do just fine.

DVD Next Copy neXt Tech Minimum System requirements:

  • Windows 2000, XP
  • Pentium III 500MHz or equivalent
  • 256 MB of RAM
  • 10 GB of free hard drive space
  • A DVD writer and Media

DVD Next Copy neXt Tech Recommended System requirements:

  • Windows XP, VISTA, Windows 7
  • Pentium IV 1.4GHz or equivalent
  • 512 MB of RAM
  • 10 GB of free hard drive space
  • A DVD writer and Media

If your PC meets the minimum system requirements of this DVD copying software as stated above, you may proceed to the installation procedure below.

1. Download DVD Next Copy neXt Tech. Then click save.

2.  Save the installer into your hard drive, preferably on the Desktop. To do this, click on the drop-down menu, and choose ‘Desktop’ in the menu list. Then click ‘Save’. (On some Windows settings, a side panel may have a ‘Desktop’ shortcut, as seen on the screenshot below).

3. Make sure you tick off the ‘Close this dialog box…’ so that the panel stays open after the download is completed. It takes about 5 to 15 minutes (depending on internet speed) to fully download the neXt Tech DVD burner software.

4. When the DVD software download is completed, a ‘Run’ button will appear, along with ‘Open Folder’ and ‘Close’ (might vary). Click ‘Run’…

5. Click on run again.

6. The DVD software installer’s Setup Wizard will open. After you specify a language, click ‘Next’.

7. Click next again.

8. The Setup Wizard will take you to the License Agreement page. Read the statements and click ‘I Agree’ (assuming you agreed with the terms of the agreement).

9. The DVD rip software installation process will now begin. Depending on the speed of your computer, the installation process will be completed by 3 to 5 minutes.

Important:
Please note the allowed installation is limited to only two computers for each Next Tech License Code purchased.

After the installation is completed, you will be automatically redirected to Next Tech’s License and Product Activation panel as you run DVD Next Copy neXt Tech the first time.

Activation:

Step 1: Make sure you are connected to the internet. Run DVD Next Copy neXt Tech and click on the middle link in the License popup to start the License Manager. It may take up to 30 seconds for the license manager window to open, while it checks with the activation server.

Step 2: Enter your license you received with your purchase email. You may copy and paste you license code into the field. If you type in your license code, use only the number (0) and not the letter O. Click on Activate.

Step 3: You will receive a popup telling you that your software successfully activated. Click on OK.

Congratulations! You have successfully installed DVD Next Copy Next Tech on your computer.

To know more about this amazing DVD Burning Software -- CLICK HERE:
 

Copyright © 2010 DVD Burning Software.